Orbitco-CCNA-Pastquestions.com

Helping You Pass Your CCNA Exams
 

ICND 1 Routing Questions 1.

 
 
 
This is an Updated real CCNA exam question (June 2012). As usual, take time to read through the question so as to clearly understand what Cisco want you to do.
 
Note: This routing questions are used for demonstration only; you might see different IP addressing and Port allocation in the real Cisco ICND exam. But it all work the same way if you could understand the technique.


I suggest you use packet tracer for practice.

Instruction:

Refer to the topology. Using the information shown, answer the five questions shown on the Questions tab.

orbitco-ccna-pastquestions.com
 

Question 1:

On which router should a default route be configured?

A - on the ISP router
B - on R1
C - on R2
D - on R3
E - on R4 

 Answer: B

Exlanation:

A default route, which can also be called the gateway of last resort, is the network  route that can be used by the network  router to route IP packet to a destination when no other known route exists.

The default route in IPv4 is 0.0.0.0 0.0.0.0 or 0.0.0.0/0. This is  often called the quad-zero route.

Question 2:

With all links operational and all routers converged, which of the following describes the messaging between routers?

A - Hellos are sent every five seconds.
B - Multicasts are sent every 60 seconds.
C - Broadcasts are sent every 30 seconds.
D - No messaging unless the topology changes. 

Answer: C

Explanation:

RIP uses broadcast User Datagram Protocol (UDP) data packets to exchange routing information. The Cisco IOS software sends routing information updates every 30 seconds; this process is known as advertising.

Question 3:

Which of the following describes the route update process if the interface from R4 connected to LAN 4 goes down?

A - No updates occur
B - R4 tells both R1 and R3 the network not accessible. Both R3 and R1 updateR2.
C - R4 tells only R1 the network is not accessible. R1 updates R2 and R2updates R3.
D - R4 tells only R3 the network is not accessible. R3 updates R2 and R2updates R1. 

Answer: B 
 
 
Question 4:

Why would RIP be used rather than static routes on R1, R2, R3, and R4?

A - RIP creates more accurate than static routes.
B - RIP uses less network resources than do static routes.
C - RIP is supported by more different vendors equipment than static routes.
D - RIP requires less configuration to automatically adjust when links go down than static routes.

Answer: D

Question 5:

On which router should a static route be configured?

A - on the ISP router
B - on R1
C - on R2
D - on R3
E - on R4 

Answer: A

 
 
 


 
 
 
 
Sign Up For Post Updates

* required


*



Email Marketing by VerticalResponse

 
 
 

 PrivacyPolicy  Contact Us  Advertise

Copyright  2012. Orbitco-Computer-Solutions.Com. All rights reserved.  

The information provided on this website is for informational purposes only.
orbitco-ccna-pastquestions.com makes no warranties, either expressed or implied, with respect to any information contained on this website.

orbitco-ccna-pastquestions.com reserves the right to change this policy at anytime without prior notice.
Cisco
and All related product mentioned in any portion of this website are the registered trademarks of Cisco.com 

and their respective owners