Orbitco-CCNA-Pastquestions.com

Helping You Pass Your CCNA Exams
 

CCNA Drag and Drop Lab Question 1.

 


 

This is an Updated real CCNA exam question (June-2012). You might see different IP addressing, VLAN configuration and Port allocation and Configurations.

As usual, take time to read through the question so as to clearly understand what Cisco want you to do.

Note: This drag and drop Lab are used for demonstration only; you might see different IP addressing and Port allocation inthe real CCNA exam. But it all works the same way if you could just understand the technique.

I suggest you use packet tracer for practice.


Question:

You have been hired by IMAP Hardware Incorporated to document the layout of the network. Complete the following tasks:

Complete the network topology shown in the graphic by dragging the labels below with the appropriate router types, interface types, and IP addresses to the graphic . Find the information you need by using the router console attached to the R-Centre router.

 
 
CCNA Drag and Drop Question
 
 
 
 
 
 
 
Answer and Explanation:

This works like troubleshooting questions. According to the question from above, you can gain access to the console of the R-Centre router by clicking on the PC.

Firstly, to view the type of neighboring devices, use the show cdp neighbors command; you will seea similar outputshown below:

orbitco-ccna-pastquestions.com

A brief explanation of the output above:

Device ID: The name of the neighbor device ; either the MAC address or the serial number of this device.

Local Interface: The protocol and port number of the port on the current device -  device you are running cdp from.

Holdtime : The remaining amount of time, in seconds, the current device will hold the CDP advertisement from a transmitting router before discarding it.

Capabilities: The device type of the neighbor. Thisdevice can be a router, a bridge, a transparent bridge, a source-routingbridge, a switch, a host, an IGMP device, or a repeater.

Platform: The product name and number of the neighbor device.

Port ID: Neighbor's remote port type and number where you receive the cdp information.
 

From the diplay above , the Local Interface, Platform and Port ID columns, this helps us to identify where these four routers and their corresponding ports should be placed . See the result below:

CCNA Drag and drop Question
 

Finally, to find out the IP addresses of the corresponding routers, use the show running-config command on R-Centre

CCNA drag and drop question 

The above output displays the ip address configuration of the four neighboring routers on the same network with the R-Centre, the result can be seen as below:

CCNA Drag and drop question 
 
 
 
 


 
 
 
 
Sign Up For Post Updates

* required


*



Email Marketing by VerticalResponse

 
 
 

 PrivacyPolicy  Contact Us  Advertise

Copyright  2012. Orbitco-Computer-Solutions.Com. All rights reserved.  

The information provided on this website is for informational purposes only.
orbitco-ccna-pastquestions.com makes no warranties, either expressed or implied, with respect to any information contained on this website.

orbitco-ccna-pastquestions.com reserves the right to change this policy at anytime without prior notice.
Cisco
and All related product mentioned in any portion of this website are the registered trademarks of Cisco.com 

and their respective owners